The main changes for the V1.1 frame are below (the green pieces are the new parts that are being added in)
-
The plate on the side is for extra support I’ve noticed a few people put a slight bend in their frame if they do a hard butt landing. So the plate is to move the point at where it would bend farther down and that makes it about 40% more stronger.
-
The main center frame now breaks down into top and bottom sections. It is slotted in with ABS connectors. Because the frame is straight in that sections longer abs connectors can be used (unlike the outside cage ring which has a curve) so the center frame can still remain very stiff like V1.0 Sp140 frame.
This allows for easier transport not just for the user but also lowers the shipping cost to the end user (especially for international shipments). Also in the case of the frame getting damaged in operation just the section that needs replaced can be ordered, saving cost.
Shipping cost are insane right now and I don’t expect it to come down anytime soon. So this V1.1 frame address a few things with this update. Also its still cross compatible with V1.0 frames so replacement parts can be easily swapped if needed.
As for an update most of the remaining parts will be in at the end of the month. Right now Dudek harnesses are still the last thing expected to be in. We are expecting the first 25 harnesses to be in from Dudek at the beginning of the month and then every 1.5-2 weeks we will be getting another 25 harnesses until they send all that are on order. So for you if you are towards the beginning of batch 2 order list you should be getting shipped out when the first 25pc are in.