3D Printing Files for Connectors

[GliderPilot (Paul Butler)]

The files at the bottom of this post work really well:

BE CAREFUL - very thin tips

Important! Sorry guys but there is design flaw with my design created by the intended print orientation. I was hoping if I printed them solid that the layer adhesion would be strong enough but while removing the hoop I broke a tip (I leveraged on the tip too much with the hoop). It split through the layer lines like wood splits with the grain. [image] As a solution to prevent the others from breaking I installed a 1-5/8 inch long grabber screw. [image] I just pre-drilled and countersunk…